){kind=link}
White: Ground / Black: Identification Bar / Yellow: Left Turn Signal / Green: Right Turn
Product Features
- 1 multi-functional 15″ light bars. Function as Left Turn, Right Turn, Identification and Stop Light Bar 4 in 1.
- It is completely sealed and waterproof.
- Surface Flange Mount – the back panel is completely flat
- High impact polycarbonate Lens is sonic welded to the house.11-DIODE SQUARE LED LIGHT.Operate from 9-16 Volts
- DOT & SAE approved,Well made, comes with a Life time warranty. This is a very dependable light bar, it is surface mount so the installation is quite easy. Bright enough will make your truck or trailer very noticeable!
Related Posts
LED Trailer Fender Light Set/2 – Double Face 4″ LED Marker Clearance Lights 7Diode (2) Double-face dual-light Pre-Wired […] Posted in Automotive
Kunix 6 – Pack of A19 LED Light Bulb ComfortVIEW, 9W (60W Eq.), Crystal White Glow (5000K), 800 Lumens, Medium Screw Base (E26), Wide Flood Light Bulb, 120° Beam Angle, UL and ENERGY STAR Listed
Kunix A19 LED 9W Light Bulb
Now is […] Posted in LED Bulbs
Ultra Bright 4 LED Rechargeable Solar Desk Lamp – Use as A Reading Light, Nightstand, Garage, Outdoors, Camping, RV, Attic Etc. (White) Trust Precision Works To Bring You The […] Posted in Solar Lighting
Very bright, well sealed 15 hitch LED light good light. Seems to be good quality. All the lights function and are very bright. Brighter than my tail lights. I added it to a hitch mount carrier.It received only 4 stars because the turn signal wiring is reversed. The yellowAnd green are opposite to your hitch wiring. If you have a 4pin hitch connector.There is a top and bottom and its labeled top. I originally figured I could flip it over but it is marked for which end is up. Just wore it up accordingly…
If the light was flat, it would be perfect. I really like how bright the LED’s are and that one bar can do everything at the same time (running, stop, left and right blinkers). I drilled holes for the wires and installed on the trailer. Then I noticed a crack in the middle of the light – did not think much of it and considered it a defect or shipping damage. I requested a replacement and received it promptly. I did a closer inspection of replacement light and noticed that the light bar has a concave shape to it (the ends of light stick…
Bought to use on a custom flatbed project, works great and was exactly what I needed! I love these lights. I welded and fabricated a custom flatbed on a Toyota Tacoma. The outside edge of the whole flatbed is 3″ aluminum c channel so I had limited vertical space to mount these lights inside the c channel (about 2.5″). They fit perfectly and were fairly easy to drill the mounting holes for. One thing to keep in mind before you drill is that they are not 100% symmertrical on the back, and the big hole you have to drill for the wires to go through will be either slightly to…
Comments are disabled for this post.