The Ultimate In Tailgate Lighting: Command attention with every signal
Bombard those behind you with a volley of 1,200 powerful LED’s. Three complete rows of lights dedicated to maximizing your pickup’s presence with an attractive and unique beam of light
Exclusive “1-2-3” Sequential Turn Signals
While other tailgate turn signals are just a standard “blink”, the Triple Stack gives your truck a distinctive and sporty look with “1-2-3” SEQUENTIAL RED turn signals. The same style used by a certain American-made muscle car and only offered by Redline.
Go Ahead, Take It To The Lake
A lot of folks claim to be waterproof, but Redline actually is.
Using a rust-resistant aluminum body and an IP67 waterproof silicone, REDLINE is protected end to end
from any sand, dirt, dust, snow, or water
Can Handle a Minnesota Winter
It’s not always sunny in Minnesota, but that’s OK!
Redline is a built to last even at negative 20 Fahrenheit!
The best part…no drilling required!
Made to be as a simple and strong as possible.
Simply peel, prep, press onto your pickup and this add-on is as good as factory installed
Comes with a tough-as-nails adhesive enhancer that increases
hold strength over 5x. No need to drill, it ain’t goin’ anywhere
Plug ‘N’ Play Ready
Plugs directly into you trailer adapter for a quick install. (Reverse light may require wiring, instructions provided if needed)
Product Features
- The MOST POWERFUL TAILGATE LIGHT Bar: An attractive and unique beam of light powered by 1,200 LEDs
- COMMAND ATTENTION LIKE NO OTHER with the exclusive RED “Mustang-style” sequential turn signals
- SIMPLE & RELIABLE: Just press n hold, the heavy duty 25lbs-rated adhesive will do the rest. NO DRILLS
- BACKBONE OF A BEAST: Rust and water resistant with a weatherproof -20F rated rigid aluminum frame
- INSTALL YOUR WAY: Use the no sweat 4-pin tow plug or hard wire for a clean OEM look. Your Choice
Awesome Light bar and works easily with Curt 55384 T connector I just installed this with the Curt 55384 T Connector. It is the cleanest, easiest way. No need to tap into the wire in your tail light. You will tap into the reverse wire in the T Connector. If you mess anything up, get another CurtT connector. I don’t see how anyone can mess this up though.See the picture I have posted of the T connector wiring. You need to find the “reverse light wire.” IT IS THE WHITE CENTER WIRE THAT GOES FROM THE CENTER OF THE MALE PLUG TO THE…
2017 Tundra CrewMax 4×4 I used the CURT 55384 T-Connector (also picked up on Amazon) for a super clean installation. I tapped into my reverse light and it looks slick. I can’t recommend this light enough. I have had others on my previous 2012 CM Tundra and this one is by far the best. It has an aluminum backbone with double sided automotive adhesive. This thing is super easy to install and looks great. It clears the tailgate in any position (high or low) so you should be able to adjust to leave enough room for…
Less than a week and LEDs are already not working on this… For this price point I’m disappointed that it already has 5 red LEDs grouped together that are out and 3 white ones that are significantly dimmer than the others that are grouped together too. I received this on 7/3/17 installed it on 7/4/17, and yesterday 7/10/17 noticed this… very disappointing.UPDATE: DO NOT BUY! Mine was defective in less than a week and they do not stand behind the product nor honor their 2 year warranty… terrible customer service… they don’t care if…
Comments are disabled for this post.