PROTECT YOUR TRUCK
Give them 72 bright reasons to keep their distance at every stop. With 72 red LEDs spread throughout a 60″ flexible tailgate light bar, maybe now, they’ll get of their phones.
FOUR SEASON PROTECTION
SPE tailgate light strips are sealed in a IP65 waterproof silicone for protection from the elements. Whether it’s a winter blizzard or a wet thunderstorm, moisture is sealed out leaving each LEDs running longer and brighter even in the worst conditions.
MOUNTS ON ANY SURFACE
Its flexible silicone design with its 3M VHB Adhesive Tape can adhere to nearly any surface possible. Stick it onto the uneven surface commonly below the tailgate and it’ll stick for years! Just clean the surface and then peel & stick!
Perfect for any work truck, pick-up truck, SVU, off-road vehicles, trailers or RVs.
TAILGATE LIGHTING SPECIFICATIONS
DRIVING- RED – 20% Brightness
BRAKE- RED – 100% Brightness
SIGNAL- RED – 100% Brightness
REVERSE- WHITE – 100% Brightness
10-MINUTE INSTALLATION
Setup is quick and painless with self-adhesive 3M adhesive and a pre-wired trailer harness connector. Detailed instructions included.
INSTALLATION SUMMARY
1. Clean Surface
2. Peel & Stick
3. Connect trailer harness
4. Connect reverse wire with included T-Tap
WHAT’S INCLUDED?
60″ Tailgate Light Strip with 3M Adhesive Backing
Inline Fuse Housing with Fuse
Pre-Wired Trailer Connector
Mounting Hardware
SPE 1-Year Warranty
Product Features
- [60 INCHES] – Super bright LED light coverage from end to end. Fits most pickup trucks, SUVs and RVs.
- [DRIVING AND BRAKE LIGHT] – Keep those behind you at bay with 72 bright LEDs. 50% brightness while driving and 100% while braking.
- [RED SIGNAL LIGHTS] – Extend your truck’s signaling power with 30″ of red LEDs on each side. Signal any direction and our SPE tailgate will signal with you!
- [WHITE REVERSE LIGHTS] – See and be seen with super bright LED lights that activate with your vehicle’s reverse lights.
- [10 MINUTE INSTALL] – Our SPE tailgate light strip will connect directly to most 4-pin trailer harness. Reverse white light feature requires splicing into the vehicle’s reverse bulb power source.
Comments are disabled for this post.