I love these LED tubes and installed them everywhere I could, BUT… BE PREPARED! After disconnecting the power installation can go from really easy to incredibly difficult. I installed these tubes in three locations. There were no less than seven different types of florescent fixtures to deal with. The ballast resistor must be disconnected or removed from every florescent fixture for these LED’s to function correctly. Some newer florescent fixtures are made so they almost cannot be taken apart. This is especially true for the fixtures with electronic…
A great way to update light panels in a drop ceiling. I used these in standard 2 foot by 4 foot four-tube T-12 (inch and a half diameter) fluorescent light panels in a drop ceiling. It was much easier and far less expensive to remove the ballast and rewire than it would have been to pull the old panels down and replace the entire fixture. The light tubes arrived on schedule and as described. These particular tubes require the hot connection at one end and the neutral at the other end. The instructions in the package showed this and there is also a…
I love these LED tubes and installed them everywhere I could, BUT… BE PREPARED! After disconnecting the power installation can go from really easy to incredibly difficult. I installed these tubes in three locations. There were no less than seven different types of florescent fixtures to deal with. The ballast resistor must be disconnected or removed from every florescent fixture for these LED’s to function correctly. Some newer florescent fixtures are made so they almost cannot be taken apart. This is especially true for the fixtures with electronic…
A great way to update light panels in a drop ceiling. I used these in standard 2 foot by 4 foot four-tube T-12 (inch and a half diameter) fluorescent light panels in a drop ceiling. It was much easier and far less expensive to remove the ballast and rewire than it would have been to pull the old panels down and replace the entire fixture. The light tubes arrived on schedule and as described. These particular tubes require the hot connection at one end and the neutral at the other end. The instructions in the package showed this and there is also a…
Comments are disabled for this post.