AUTOSAVER88 6pcs 1156 13-SMD Super Bright White LED Bulbs for Replacement of Turn Signal Light Car Back up Parking Tail Light 5050 6500K 12V 1129 1141

LEDdistributors • 7 years ago

Specifications:
-Voltage: DC-12V
-Lumen:200LM
-Lamp bead type:5050
-Color:White
-LED Type: 1156-13SMD
-Color Tempurature:7000K
-Operating Time:5000+ hours
-Base Diameter: 16mm or 0.6 Inch
-Total Height: 40mm or 1.6 Inch

Features:
-Cross Reference: 1156 1073 1093 1129 1141 1159 1259 1459 1619 1651 1680 5007 5008 7506 7527 (Single)(For Reference Only)
-Application: Great for Rear Turn Signal Light Also Common use for Car, Trailer,Camper, Backup Reverse Light,
Interior Light, Tail light, Corner light, Stop light, Parking light, Side marker light, etc.
-Simple installation Plug and play No need to change the line& standard connector & without matching problems.
-Energy efficient, power consumption is only 6% of traditional light bulbs.
-Low heat, low power consumption, low heating temperature to improve traffic safety
-High luminous brightness, LED1W = 5W traditional bulbs.

Notes:
-The installation is not bright, then change the direction on the line.that is, change the electrode.
– without replacing the original car circuit directly.
– replace the lamp must be in the flame state or can not be used.
-Note that the vehicle voltage is 12V, does not apply to RV truck cars on board
because sometimes the voltage and current suddenly increases.

Product Features

-Led is Completely Encapsulated in Epoxy Resin, Which is Stronger than Bulbs and Fluorescent Tubes.
-The lamp body also has no loose part. Each wick has three luminous points, one more than the traditional three, high purity, light angle of 180 degrees less than HID and incandescent heat radiation. Low power consumption, long service life. 5050 patch has three light points. Light intensity can reach 5500-6000MCD
-Circuit board: shock, compression, will not be high temperature damage, the overall design will not damage the circuit board, can improve lamp life.
-High-quality aluminum lamp, the surface anodized, with strong corrosion resistance.
-Welding: SMD welding process to eliminate the defects of manual welding neat and full of each solder joint.