This is a double-end input T8 1.5FT LED tube light with 7W total input power to replace 12-30V F15T8 energy-saving fluorescent. It is not dimmable and works from 10-30V DC.

****WARNIN I: It’s a 12-30V DC LED tube light! NEVER use it with AC 110/120VAC source unless you have an AC-DC converter to achieve 12-30V DC power. Please check your fixture voltage before buying****

****WARNING II: Actual Length 17-3/4″ pin to pin! Please measure your old bulb to confirm the fitness. If your fluorescent bulb is fully 18″ pin to pin, it doesn’t fit! ****

****Installation: Fixture Rewiring is Easy but Required! The installation manual is the 2nd photo at the upper left corner of this product page. The manual will also be enclosed inside the package shipped to you. Please ensure to follow the manual to install this LED light! It must be directly wired to your 12-30V DC power from the two input ends on both sides without the use of any electronic ballast or starter. Ask help from an electrician if you don’t have enough electrical basics! ****

Product Features

  • MUST be directly wired to the 12-30V DC Power: Disconnect Ballast & Starter if there is any! Installation Manual is attached as the 2nd photo at the left upper corner of this product page! ***DON’T BUY UNLESS YOU UNDERSTAND THIS!***
  • Ideal for RV and Marine Lighting: To replace 12-30V DC 18″ CFLs with Instant-On Daylight 6000K!
  • Actual length 17-3/4″ from pin to pin: Please measure your old bulb or light fixture to confirm the fitness before buying
  • Rotatable: light forwarding angle can be adjusted by +-90 degrees to fit any light fixture!
  • Low heat, eco-friendly, and saving >50% electricity

Share Button

Related Posts

Sovrn