SURFACE MOUNT INSTALLATION
Step1) Prior to installation. Please install two screws (furnished)into the junction box. Do Not drive screws completely to the end of the junction box.
Step2) Connect supply wires to wires in fixture wiring box with proper size wire nuts or push wires into “push-in” connector. Connect white to white, black to black, and green or bare copper wire to bare copper wire.
Step3) The ground wire at the service junction box may need to be secured to a ground screw.
Step4) With a Phillips screwdriver, attach the disk light tightly to the j-box.
Step5) Complete the installation by twisting the diffuser on the disk light aluminum enclosure and lock the diffuser in place.
Step6) The edge of the fixture and the ceiling use waterproof silicone to seal.
WARNING:
For your safety read and understand instructions completely before staring instructions. Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
1.Risk of Fire
Supply conductors (power wires) connecting the fixture must be rated minimum 90℃. If uncertain, consult an electrician
2.Risk Of Electric Shock
Disconnect power at fuse or circuit breaker before installing or servicing
3.Risk Of Fire/Electric Shock
If not qualified, consult an electrician
CAUTION
THIS PRODUCT MUST BE INSTALLED IN ACCORDACE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
Product Features
- 1- LED disk light makes it easy to upgrade your existing recessed lights to energy efficient LED or flush mount on junction box for new construction site to avoid using recessed can
- 2- Provides surface mount light for 3” and 4” junction boxes & fire rated boxes. It is suitable for use in dry, damp or wet location such as shower room/fire box around
- 3- 120V operation with TRIAC/ELV dimming down to 10%, 600 lumens of pleasant, low glare Warm White light.
- 4- Saves up to 80% in energy consumption comparing to incandescent lamp, 50W halogen equivalent. cETLus Listed.
- 5- Easy installation and instant on make you feel convenient and different from what you used to have for light up your room.
Mounted in a ceiling junction box, it looks just like a nice ceiling “can light”! We purchased two of these lighting units to solve a problem remodeling a basement room for a home theater. We needed the ceiling lights to be flush with the ceiling so that nothing would be in the way of the projector beam.These units mount into an ordinary junction box, but when installed look like recessed can lights. This is a great idea — the ability to take any ceiling junction box and give it the appearance of a ceiling can light, flush with the ceiling.This…
WAY….. easier than traditional can lights I am remodeling a house right now and built my last home which had over 75 can lights in it. These are a great advancement over traditional can lights that are clunky, far more complicated to install, require you buy LED bulbs at added cost, etc. The 4″ version literally screwed directly into my mud rings which are mounted on a simple standard junction box. (cost at Menards or Home Depot for both is about 3.00 bucks). At first I was going to use these in strategics locations…
Comments are disabled for this post.