IMPORTANT:
Read all instructions before installing fixtures. Retain for future reference.
SAFETY:
For your safety, this fixture must be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician.
WARNING:
Make certain power is OFF from the electrical panel before starting installation or attempting any maintenance. Indoor installation only.
TOOLS REQUIRED:
1.Saw
2.Measuring Tape
3.Electrical Wiring (use type and gauge suitable for application to connect the fixtures)
PRE-INSTALLATION:
1.Turn power OFF from the electrical panel before starting installation.
2.Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
3. Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.

FIXTURE INSTALLATION:
1. Connect the fixture to the hardwire box by inserting and twisting the male/female connectors.
2. Push spring loaded clips on the fixture upwards and insert fixture base in to mounting hole. Release the clips and fixture will be pulled flush to the ceiling.
3. Once assembly is complete, turn on power to confirm fixture is working properly.
Hole Cut Size
4-1/4”. Please follow the cut out template with the product.

Product Features

  • 4″ round LED light fixture with isolated external driver installed inside junction box.
  • Ultra-thin, 1″ thick LED fixture, edge-lite, consumes 9W, emits over 550 lumens at 3000K and CRI 80+, offers comfortable Warm White light and less glare to eyes.
  • Type IC rated, approved for direct contact with insulation and NO pot light housing is required; Air-tight and suitable for damp location.
  • For new construction, insulated and dropped ceilings, easy to install into the 4-1/4″ cut out.
  • Dimmable with triac and ELV dimmers; cETLus and Energy Star Certified.

Share Button