){kind=link}
20 Amp 12 Volt ON-OFF Rocker Switch LASER ETCHED WITH TWO L.E.D. LIGHTS Single Pole Single Throw ON-OFF Switch. Black hard surface rocker. Surface size is 2″ (50mm) x 1″(25mm). Standard size mounting hole 1.41″(36mm) x .86″(22mm). This is the standard size of most switch holes in modern vehicles. Upper light is ON when the switch is pressed UP. Lower LED is independent and can be wired to separate dash light circuit. Both LEDs have separate grounds. No rear barriers between terminals. Lower light Waterproof rating of IP66. All symbols are laser etched directly onto the switch face to ensure long image life.
Product Features
- 20 Amp 12 Volt ON-OFF Rocker Switch
- LASER ETCHED WITH TWO L.E.D. LIGHTS
- Single Pole Single Throw ON-OFF Switch
- All symbols are laser etched directly onto the switch face to ensure long image life.
- Black hard surface rocker
Related Posts
24 inch LED Under Cabinet Light, 1200 Lumens, Warm White 3000K, White, On/Off Switch, Plug in, Energy Star Provide light to any area with our 24 […] Posted in LED Lighting
Brizled Linkable LED Shop Lights, 4ft 42W ETL Certified Shop Lights, 4200 Lumens Double Integrated LED Garage Lights Fixture, 5000K Daylight Work Light for Ceiling, Workshop, Basement, Frosted, 2 Pack Brizled Utility LED Garage Light & […] Posted in LED Lighting
80 Watt E39 LED Bulb – 9,600 Lumens – 3000K / 2700K -Replacement for Metal Halide, HID or CFL – High Efficiency 130 Lumen/ watt – 360 Degree Lighting – LED Corn Light Bulb RuggedGrade 2017 LED Corn Light Bulb […] Posted in LED Bulbs
Headlight rocker switch.
These are real nice looking switches. And they seem to be well constructed. I have them mounted in a plastic panel on my Kubota tractor. Since it didn’t have any holes in that panel I had to have holes cut into it. As soon as I looked at the switches I knew I was in trouble. There is only about 1/16” on each side to cover the hole so I knew it had to be very accurate so I took the switches and plastic panel to a local machine shop and had them machine the holes in the panel with a…
Comments are disabled for this post.