LED Lighting Distributors

The MICTUNING brand one lead Heavy Duty LED off road light wiring harness is designed and made specifically for high output light bars which has substantially higher amperage draw than its smaller counterparts. With each of the harness so one can power up multiple apparatus off of a single on/off switch. Composed of 14 gauge wires, heavy duty , and a 40 amp relay, the MICTUNING wiring harness can be used to power up the largest 300 Watt LED off road light bar. An illuminated on/off ROCKER SWITCH, and more than 12 ft of wiring, this wiring harness for LED off road lights simplifies the installation process of powering various equipment on all automobiles.

Interchangeable/Compatible with:
All automobiles and devices equipped with a 10 to 30 Volt DC power source.
Features:

IP65 waterproof illuminated on/off rocker switch
40A Power Relay
30A Blade Fuse
More than 12ft of wiring from battery to light fixture
Accessory included from combining and powering multiple harness of off single switch

Product Content:
1 x Wiring Harness + User Manual
Full Wiring Kit with ROCKER SWITCH ON/ OFF switch for All Light Bars especially 240 Watt or 300 Watt
Installation:
1. connect the the red+ wire from the fuse to battery +; connect the black wire from the relay to the battery ¨C;
2. connect the wire for lights bar from the relay; (red/black correspond to the wire of lights bar)
3. turn on on/off button of switch to test the lights bar

Product Features

• with illuminated ON/ OFF ROCKER SWITCH; easy to install,
• Max rated at 30A, 40A Power Relay, 30A Blade Fuse; Suitable for MICTUNING LED light bars 20″ +/ above 120 Watt
• More than 12ft of wiring from battery to light fixture
• Accessory included for combining and powering multiple harness of off single switch; Heavy Duty with 14 AWG wires; with it you can power up a heavy duty off road light bar above 120 watt
• CAUTION: If the wiring harness wired to battery+/- directly, the rocker switch glowing even when the vehicle is off; it will stop glowing only if it is hooked to a source on your fuse panel that is activated by the key; dont let the wiring harness short circuit, it will be melt.