The wiring harness for LED off road lights is the perfect accessory for off road vehicles, working vehicles, and any automobile that could use a relay to power specific equipment. Consisting of a relay, an illuminated on/off laser rocker switch, and more than 12 feet of wiring, this wiring harness for LED off road lights simplifies the installation process of powering various equipment on all automobiles. Interchangeable/compatible with: All automobiles and devices equipped with a 10 to 30 volt DC power source. Features: Illuminated on/off switch, power relay, 30A blade fuse more than 12ft of wiring 2 sets of power connectors to light fixtures Product content: 1 x wiring harness full wiring kit for all light bars with laser rocker switch on/ off switch for 7”, 10”, 13”, 20”, 30”; 40”, 50” installation: 1. Connect the the red+ wire from the fuse to battery +; connect the black wire from the reply to the battery C. 2. Connect the wire for lights bar from the relay; (red/black correspond to the wire of lights bar). 3. Connect the white +/black- wire of the switch to battery or any place of your car system to get power for the switch. 4. Turn on on/off button of switch to test the lights bar.
Product Features
- With laser on/off rocker switch and easy to install
- Power relay, 30A blade fuse all include to install your lights
- 2 sets of power connectors to light fixtures, can used for all LED light bars and work lights
- More than 12ft of wiring not like others only 8 ft., with this wiring harness you can connect 2 LED work light or 2 small watt LED light bar and any else off road use
- Mictuning wiring harness material passed UL certificate, not like others use cheap material
Great kit!! Can be tricky to install. I was a little hesitant to buy this set at first because it had quite a bit of mixed reviews, but I ultimately took the plunge because I really liked the look of the toggle switches. I ended up purchasing the wiring for a LED Light Bar (1 lead, 14ft), Spot Lights (2 leads, 14ft), and box mount to hold both the toggles. They are all from the same seller so instead of writing separate reviews for all three, I’ll discuss them all in this review. The mount for the toggles aren’t…
it might be good for smaller lights I installed this harness on a 1997 Jeep Wrangler to power a 50” LED Bar 288W. I went into a trail run and the LED light was heavily used. I noticed that the wire turned extremely hot. The following day I turned on the LED Light and after 1 minute of use the harness shorted and melted. Try to replace the 30A fuse and as soon I turn the light the fuse goes out (3 fuses blown out). Disconnected the LED bar and connected directly to the battery and it works. In summary this harness is not capable…
Comments are disabled for this post.