Specification: LED power: 18 w (6piece x 3W LED) voltage: 10-32 v DC beam: Flood beam LED color temperature: 6000k working life: 30000 hours theoretical lumens output: 1800 lm operating lumens output: 1260 lm working temperature: 40-85 degree waterproof rate: Ip67 material: 6063 aluminum profile, stainless steel bracket, PC lens applications: Indoor and outdoor uses back up light off road lighting truck, trailer interior and exterior lighting construction lighting garden, backyard lighting boat lighting they are aftermarket parts. Not DOT approved. Do not use if DOT is required. For off road use only. Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations.
Product Features
- SUPER BRIGHT AND WIDE ILLUMINATION RANGE: Advanced LED chips give out bright and white ray for clear visibility. Special designed lamp cup leads to wider illumination range
- BETTER HEAT DISSIPATION: Quick cooling aluminum alloy heat sinks and high-quality heat conduction silicone gel can effectively extend the lifespan of the light bar to over 30,000 hour
- HIGH PROTECTIVE PERFORMANCE: IP67 Waterproof Rate, waterproof up to 1 meter of water for 30 minutes and effectively dustproof.
- ADJUSTABLE MOUNTING BRACKET: With adjustable mounting bracket, the work light can adjust to about 45 degrees, which makes changing direction easier.
- WIDESPREAD USES: Jeeps, 4×4, Trucks, Motorcycles, SUVs, ATVs, Cars, Boats
Reverse lights for pickup truck Used for a set of auxiliary reverse lights on a dodge 1500. Backing up looking through factory tinted glass at night is a pain. So I tried brighter light bulbs but still lacking. Hooked these up by tapping into the towing harness, the seven pin not the 4 pin. Center pin is reverse. So now when the truck goes in reverse these come on. I measured each they draw about 2 amps each so its not a problem for the harness. Next the allen heads I snugged up and placed a little silicon around the cable…
spot vs flood
Comments are disabled for this post.