This is a flexible waterproof tailgate LED light strip bar tape, triple row, this is brake light, this is turn signal lamp, this is also DRL Daytime running light. This is a multifunctional and highly integrated vehicle light specially designed for pickup, truck, lorry, track or, vans etc. Specifications: brake light, reverse/DRL light color: red/ yellow/ white working voltage: 12-16v DC light source: 504Pcs LEDs LED strip length: 60″ waterproof: IP67 materials: LED chip + silicone working lifespan: over 30, 000 hours plug-n-play 4-pin flat connector, plugs directly into you trailer adapter.
Product Features
- Super bright: Advanced 60 inch triple row, 504 pcs LEDs, which makes the lumen & output is 300% brighter than normal tailgate light bars.
- 5-Function: running Red light; rear left turn yellow light; rear right turn yellow light; reverse white light; Brake yellow light.
- High quality: using the fully sealed flexible silicone tube with IP67 waterproof rate, it can still work perfect whatever it rains and snows.
- Easy install: comes with a tough-as-nails adhesive enhancer, Simply peel, prep, press onto your Pickup and this add-on is as good as factory installed.
- Widely application: completely compatible with Dodge Ram 1500 2500 3500 4500, Ford F150 F250, Chevy Silverado, GMC Sierra, Toyota Tundra, and most cars, trucks, Pickup, SUV, RV, Van, trailers, etc.





![[Pack of 4] HowFine Outdoor Stainless Steel LED Solar Step Light Wireless Super Bright Modern White Lamp for Deck, Staircase, Walkway, Patio, Garden, Yard, Patio](http://ledlightingdistribution.com/wp-content/uploads/2016/11/51Yh8KjsMEL-150x125.jpg)
Strong Construction
Reverse lights for pickup truck Used for a set of auxiliary reverse lights on a dodge 1500. Backing up looking through factory tinted glass at night is a pain. So I tried brighter light bulbs but still lacking. Hooked these up by tapping into the towing harness, the seven pin not the 4 pin. Center pin is reverse. So now when the truck goes in reverse these come on. I measured each they draw about 2 amps each so its not a problem for the harness. Next the allen heads I snugged up and placed a little silicon around the cable…
Comments are disabled for this post.