If you have any combination of a Rear Camera, Rear Parking Sensor, and/or Trailer Tow Assist but do not have a Blind Spot Sensor then you need the TRIPLE ROW REAR SENSOR 4-PIN MODULE (sold seperately on AMZ).
If you plan on hardwiring the TRIPLE ROW (recommended) then you do not need the module. If you have a BLIS or Blind Spot Detection you must hardwire the tailgate directly to your tail lights
3X MORE STOPPING POWER
The Ultimate In Tailgate Lighting: Command attention with every signal
Bombard those behind you with a volley of 788 powerful LED’s. Three complete rows of lights dedicated to maximizing your pickup’s presence with an attractive and unique beam of light
Exclusive “1-2-3” Sequential Turn Signals
While other tailgate turn signals are just a standard “blink”, the Triple Stack gives your truck a distinctive and sporty look with “1-2-3” SEQUENTIAL amber turn signals. The same style used by a certain American-made muscle car and only offered by Redline.
Go Ahead, Take It To The Lake
A lot of folks claim to be waterproof, but Redline actually is.
Using a rust-resistant aluminum body and an IP67 waterproof silicone, REDLINE is protected end to end
from any sand, dirt, dust, snow, or water
Can Handle a Minnesota Winter
It’s not always sunny in Minnesota, but that’s OK!
Redline is a built to last even at negative 20 Fahrenheit!
The best part…no drilling required!
Made to be as a simple and strong as possible.
Simply peel, prep, press onto your pickup and this add-on is as good as factory installed
Comes with a tough-as-nails adhesive enhancer that increases
hold strength over 5x. No need to drill, it ain’t goin’ anywhere
Plug ‘N’ Play Ready
Plugs directly into you trailer adapter for a quick install. (Reverse light may require wiring, instructions provided if needed)
Product Features
- The MOST POWERFUL TAILGATE LIGHT Bar: An attractive and unique beam of light powered by 788 LEDs
- COMMAND ATTENTION LIKE NO OTHER with the exclusive AMBER “Mustang-style” sequential turn signals
- SIMPLE & RELIABLE: Just press n hold, the heavy duty 25lbs-rated adhesive will do the rest. NO DRILLS
- BACKBONE OF A BEAST: Rust and water resistant with a weatherproof -20F rated rigid aluminum frame
- SEARCH: “OPT7 Module”; Add if you haveany vehicle with BLIS or Blind Spot Sensor will need to hard-wire the Triple LED tailgate to the vehicle’s taillights with the included hard-wire extension kit
Awesome Light bar and works easily with Curt 55384 T connector I just installed this with the Curt 55384 T Connector. It is the cleanest, easiest way. No need to tap into the wire in your tail light. You will tap into the reverse wire in the T Connector. If you mess anything up, get another CurtT connector. I don’t see how anyone can mess this up though.See the picture I have posted of the T connector wiring. You need to find the “reverse light wire.” IT IS THE WHITE CENTER WIRE THAT GOES FROM THE CENTER OF THE MALE PLUG TO THE…
easy, and got a new one done deal for … Was going to refrain from writing a review but now I’m irritated.Bought this over a year ago. I do have a newer truck with trailer detection so had to wire it directly into my tail lights.4 months in, the brake light portion faded and stopped working. I put in for the warranty and had to pay 60 to send it back. Didn’t realize was going to cost that much until I was already there, w.e. paid it and a week later got my new one put on. 2 months later…same thing…
Less than a week and LEDs are already not working on this… For this price point I’m disappointed that it already has 5 red LEDs grouped together that are out and 3 white ones that are significantly dimmer than the others that are grouped together too. I received this on 7/3/17 installed it on 7/4/17, and yesterday 7/10/17 noticed this… very disappointing.UPDATE: DO NOT BUY! Mine was defective in less than a week and they do not stand behind the product nor honor their 2 year warranty… terrible customer service… they don’t care if…
Comments are disabled for this post.