Partsam 18LED Flexible Turn Signal Strips Indicator Blinker Light. Perfect for all 12V Motorcycles Bikes ATVs Mopeds scooters Snowmobiles, Also you can use it on Car Truck Trailer SUVs
Specification
Led Type: 18-5050-SMD
Color: Amber / Orange (similar to most motorcycle bikes stock signals)
Voltage: 12V
Extension Cable: 120CM
Lots of Common uses:
Motorcycle License Plate Blinkers Lights, Car License Plate Lights, Trailer lights, Turn Signals, Indicator Blinker Light, front and rear signals, Running Lights, accent lighting etc.
Waterproof Design:
With the IP65 Waterproof Silicone built, it will prevent from any sand, water, dirt, snow or dust.
Adhesive Tapes:
Each strip is backed with super stick tape for easy mounting. With the Pre-installed Adhesive Tape on backside of the strips, you can mount it anywhere. Also it can easily be bent or curved to desired position.
Package included: 2x led strip light
Product Features
- This 12inch motorcycle led strip light bar come with 18LED super bright amber 5050 LED Beams, Universal for Motorcycle License Plate Lights, Car License Plate Lights, Trailer lights etc
- Universal Tail Light Brake Light Blinker fits for Cars SUV Vans Truck Motorcycles Bikes ATVs Scooters Motorbikes Harley David ect.
- EASY TO INSTALL: 2 Wires Connection: Black is Negative and Red is Positive. Note: you need to connect it to the relay then it could blink!
- Each strip is backed with super stick tape for easy mounting. With the Pre-installed Adhesive Tape on backside of the strips, you can mount it anywhere. Also it can easily be bent or curved to desired position.
- With the IP65 Waterproof Silicone built, it will prevent from any sand, water, dirt, snow or dust.
Best LED blinker strips for the price! These LED strips are a very bright amber and extremely visible. Holding up a 100w light bulb to the LED’s was insufficient to fade the LED’s light output. At $10.29 for 2, these LED’s are an extremely good deal. These are virtually invisible mounted on the rider peg mounts, but clearly visible once the turn signals are activated, and are even visible from the sides of the bike. The 3M adhesive strips on the LED’s are extremely sticky and a little hard to pull off the red protective backing, but…
Great for what you pay. Get resistors! Installed these on the passenger foot rests as turn signals on my Honda f4i so I could remove the bulky old turn signals and stream line the back of the bike more. Install was easy. The lights work nicely and are about the same brightness as the old turn signals. I had to wire in a resistor with each LED to stop the hyperflash. Also siliconed the ends to be safe. Only reason for the for four stars is because the lights themselves are completely clear so you can see the insides and it looks…
Comments are disabled for this post.