Most states will not allow electricians or home owners to install LED products that have not been tested by a certification laboratory. This UL LISTED LED T8 meets all regulatory requirements. The UL certification is indication of a superior quality product that has passed numerous tests before getting its approval.
Product Features
- Top Rated T8 LED Tube Single Sided Connection with G13 Base
- ✅ 2 FOR 1 – Convert to LED with Sunco for instant energy savings (up to 85%), 1 LED tube does the job of 2 fluorescent tubes! Our T8 LED tubes provide instant bright light (+120 lumens/watt), no flickering for maximum eye comfort.
- ✅ COMMERCIAL GRADE – We uphold the highest standards for all our products by testing each product for optimal performance and safety. Certifications: UL. Specifications: Length 4 FT / 48 IN, Frosted Cover, Color Temperature 5000K, Wattage 18, Lumens 2200, Voltage 120-277, Beam Angle 120, Shatter resistant, Flicker Free, Instant On, Long Lifetime, Sustainable.
- ✅ EASY INSTALL – Installation in 5 minutes or less! Locate the ballast, cut the hot and neutral wires then cut the socket lead wires and connect the input wires to the output wires to bypass the ballast. Requires non-shunted tombstones, not included.
- ✅ SUNCO BENEFITS – 5-Year Warranty! Sunco is proudly based in the USA, offering quality products at affordable prices backed by industry-leading warranties and knowledgeable support specialists.
not quite up to snuff I’m returning these tubes to Amazon as they don’t produce as much light as ‘i beleive’ they should. I have been refitting all my flourescent fixtures to LED. I have purchased hyperikon and SGL from Amazon; and now these Sunco. I could tell almost immediately that the Sunco where not as bright. I have a background in electronics so I used a digital light meter at a set distance from the same fixture and measured pairs of all three. The Hyperikon had an output of 1350+ lumens; Next…
All good to go, but need better instructions Arrived in two days. All intact. Let me help with instructions: on T8 fixtures you do not need to remove the ballast. On T12 fixtures you DO need to remove the ballast and direct wire the sockets. However, the instructions are less than clear. On a standard T12 fixture, each socket on each end has one positive and one negative connection. That is not the case with these LED bulbs. You must wire black to one end, white to the other. However, only one pin on each end of each bulb is…
Great but required some work I removed my florescent light tubes and plugged these LEDs in and they worked, sort of. In a two tube fixture, one LED was noticeably brighter than the other. Then they flickered and had trouble turning on when I flipped the switch. Not good…So I figured the ballast from the florescent fixture might be the problem.Sure enough, bypassing the ballast did the trick. The LEDs are bright, come right on and don’t flicker.However, bypassing the ballast on 5 fixtures is no small…
Comments are disabled for this post.