Tail lights: All red LEDs light up
Rear left turn signal: Left LEDs light up
Rear right turn signal: Right LEDs light up
Brake: All Red LEDs light up
Reverse: All White LEDs light up
Specification:
Material: A total of 90 LED lights (30 white LED lights, 60 red LED lights)
LED Strip Length: 60 inch/1.5m
Power Cable Length: 43.3inch/1.1m
Power: 2.5W
Voltage: DC12V-14V
Waterproof Grade: IP65
Fitment: Suitable for most pickup trucks SUV
Professional installation is highly recommended (No instruction included)
Package Details:
1 set LED strip tailgate light
Warning:
Images only for reference,please measuring your truck’s rear tailgate plate length before buying.
Don’t bend or fold, otherwise will damage the metal sheet and lead to LED not light up
If the vehicle’s without 4 pin plug,you can try cut it and connect the cable directly.
General installation information:
1. Select desired mounting position and make sure that the surface is clean and clear of dirt, water or wax.
2. Peel off the 3M tape and stick the tailgate bar onto the car
3. Connect the power cord to vehicle (Please look at the picture below for more information) and connect the long black wire to 12V power
Product Features
- Multi-Functions: Tail light,Running and Driving light,Turn signal light,Brake light,Parking light,Hazard flashers,Reverse light and more reverse modes
- High Quality: Withstand the weather and washed,Epoxy process designed refuse moisture for long-term use,fuse overload protection,IP65 waterproof
- Completely compatible with Dodge Ram 1500 2500 3500 4500,Ford f150 f250,Chevy Silverado,GMC Sierra,Toyota tundra,and most Cars,Trucks,Pickup,SUV,RV,VAN,Trailers,etc
- Perfect Bright: 3528 super bright Korea LED source,waking up the drunks and texters behind you
- Easy Install: Mounts easily with high quality 3M automotive adhesive,plug the lights into your trailer light plug and it just works.
For the money you can’t beat this light kit. I put them on a shaved custom truck. I tried the line of fire lights years ago but the Highway Patrol said they were not sufficient DOT approved tails. So I added DOT tails from another vehicle in my rollpan. Due to the angle of the pan, the factory swapped lights were barely viable. I was pulled over yet again. I would have just put my Line of Fire back in but due to their hard shell housing they had gotten broken in storage. So I needed something…
This light will brighten up your day or night! I like that it has 3M double sided tape the entire length of the strip which makes installing it so easy. Just center the light and start sticking it in place. The wiring is also very simple. It comes with the 4 pin trailer connector so you can plug that right in and be good to go. You will have to wire up the reverse lights with the corresponding wires on your truck. I pulled one of my Tail lights out and spliced the wire from my factory reverse…
Comments are disabled for this post.