Features:
– Everything starts with light, and the rest will happen naturally. This elegant solar lantern can illuminate your good mood with its special design.
– Touch switch. (Do not press hard, just gently put your thumb on the switch will do.)
– During the day, the solar panel transforms solar energy into electricity and recharges it in a rechargeable battery.
– Each lantern contains 1 3.7V/1300mah LED:1.2W/100LM when the light has enough sunshine, the lamp turns on automatically and can take up to 8 hours or more at night.
DIY , Customize pattern
Perfect for parties, pool & patio lighting, dorm rooms, bath time, mood lighting, weddings, holidays and as a cool gift for kids & adults.
White LED only: Half brightness at the first, and then full brightness, and then turns to flashing mode.
Note:
Please charge the lamp first before using. When the lamp is charging,the switch won’t work.If light is onwhile charging,it will turn off automatically after 10 seconds while under charging mode.(To prevent battery charge and discharge at the same time,might get damage or can’t get properly charging.) Don’t throw this lamp into the water to long. Solar lamp can be charged under strong sunlight but the bucket shell can’t be exposed under strong sunlight.
Specification:
Solar panel:5V/1.2W
Lithium Battery:3.7V/1300mah
LED:1.2W/100LM
Power on/off switch:2 sides
Material: TPU+100% ABS
Charging method: solar power+DC
Charging time: Around 8 hours by sunlight; or 3-4 hour by DC charging.
Lighting time: Full brightness 5hours; Half brightness 15 hours; Flashing 5-6 hours.
Size: Bucket:Φ150mm*175mm(H);Light:Φ135mm*12.5mm
Waterproof grade: IP67
Features:1. Separable 2.Foldable 3.Magnetic 4.Portable 5.Energy 6.Waterproof
Weight:300g
Packaging:
Drawstring bag, Lanyard, DC cable in the box.
Product Features
- Unique style: Creative spilling solar lantern bucket shapes, modern and simple style. Made of tpu+100% abs, lightweight, easy to carry.
- Multi modes: Long press 5 seconds half brightness at the first and then full brightness and then turns to flashing mode.
- Easy to operate: Remove any flat surfaces of the solar panel, after 5 seconds, the lights will turn on automatically, you can switch it off and then reset the metal again, and then switch to the next light mode again.
- Waterproof: Put this lamp in the water, float in water, and after 5 seconds the lights will turn on automatically in the water. You can take it out of the water and throw it back into the water again, until it is lit. (you cannot use your finger to turn it on when the flash is on, please dry it first.)
- Battery powered: You can use DC+USB cable or by solar DC charging time around 4-5 hours, solar panel charging time around 8-10 hours. Red indicate light will turn on while charging, when turning green, you can spend a little longer to fully charge up to 85% of the current.
I bought this back in October 2016 so I would have a new cartridge ready for my HL-L2360DW when the toner it came with ran out. I finally decided to change it today after getting tired of seeing the “replace toner” message (That starter toner lasted a real long time) only to find out that it doesn’t fit. The cartridge goes into the printer properly, but when I close the cover and printer starts warming up, I hear a loud clicking noise, and the outer panel on the printer’s left side starts…
Correction: This ink arrived as promised and packaging was intact( thank you !) When I finally got my basically new ( 2nd cartridge) printer to work, the ink was still fresh.Apparently my printer was at fault.My daughter contacted Brother and after a lot of work by my daughter and the rep, the printer is working and the ink is fine. I do not know what I could have done besides sliding the cartridge in and out !Original post so people like me can know that it is not the ink: My printer will…
Comments are disabled for this post.