This is a double-end input T8 1.5FT LED tube light with 7W total input power to replace 12-30V F15T8 energy-saving fluorescent. It is not dimmable and works from 10-30V DC.
****WARNING I: It’s a 12-30V DC LED tube light! NEVER use it with AC 110/120VAC source unless you have an AC-DC converter to achieve 12-30V DC power. Please check your fixture voltage before buying****
****WARNING II: Actual Length 17-3/4″ pin to pin! Please measure your old bulb to confirm the fitness. ****
****Installation: Fixture Rewiring is Easy but Required! The installation manual is the 2nd photo at the upper left corner of this product page. The manual will also be enclosed inside the package shipped to you. Please ensure to follow the manual to install this LED light! It must be directly wired to your 12-30V DC power from the two input ends on both sides without the use of any electronic ballast or starter. Ask help from an electrician if you don’t have enough electrical basics! ****
Product Features
- ***Please DON’T buy if you don’t expect to modify your light fixture***: MUST be directly wired to the 12-30V DC Power! Please disconnect Ballast (& Starter if there is any) before plugging in the bulb. Installation Manual is attached as the 2nd photo at the left upper corner of this product page!
- Ideal for RV and Marine Lighting: To replace 12-30V DC 18″ CFLs with Instant-On Warm White 3000K (4-Pack)!
- Actual length 17-3/4″ including pins: Replaces bulb with actual length from 17-5/8″ to 17-3/4″!
- Rotatable: light forwarding angle can be adjusted by +-90 degrees to fit any light fixture!
- Low heat, eco-friendly, and saving >50% electricity
Very easy. The lights are much brighter than the old … I purchased four of these LED replacements because the fluorescent bulbs kept burning out so often. The fixtures in my motor home hold two tubes apiece. The first fixture, I removed the whole thing and did the re-wiring job as explained on a U tube clip. That turned out well, so the second fixture I retro fitted without removing the fixture. Very easy. The lights are much brighter than the old fluorescent tubes. Very nice.I’m curious to find out how well they withstand the…
“See the light” Wow! What a difference over fluorescent! Just ordered my second set of four. Easy to convert. Changing from fluorescent to LED is really not that cost effective but…. If you have a 30 AMP coach and an Electronic Control Module, you will benefit going to LED. My ECM would cause my A/C to shed power when I turned the fluorescent lights on. The fluorescent lights would draw from the battery reserve causing the battery charger to activate which caused the ECM to divert power from different…
Great light quality!
Comments are disabled for this post.