')){kind=link}
A perfect accessory for LED strip ribbon use,to extend length between strip and controller or connect with strps
Product Features
- Suitable for 5050 3528 SMD RGB LED Strip Ribbon Light
- Length: 2.5m/8.2ft
- no need to weld
- easy to install and storage
- 4pin plug included
Related Posts
LONGKO LED Plant Grow Lights 10W Desk Clip Lamp with 360° Flexible Gooseneck for Plant Growing, Indoor Plants, Hydroponic Garden, Gardening, Greenhouse, Office Targeted Light Source Plant's grow […] Posted in LED Grow Lights
Xprite Red & Blue 16 LED High Intensity LED Law Enforcement Emergency Hazard Warning Strobe Lights For Interior Roof / Dash / Windshield With Suction Cups Compatible with:
All vehicles […] Posted in LED Lighting
Onforu UV LED Black Lights Bulb, 7W A19 E26 Bulb, UVA Level 385-400nm, Glow in The Dark for Blacklight Party, Body Paint, Fluorescent Poster, Neon Glow (2 Pack) Onforu 2 Pack 7W A19 UV LED Black […] Posted in LED Bulbs
Great item for your led lights. Picture attached.
Missing parts even after they resent the package Not sure if the product works because when it arrived, there is no “4pin plug adapter” in the package. I contacted ESUMIC about the missing parts. They wanted me to take a picture of the product (not sure about the purpose of this). I sent them the picture and a week later another package arrived with only one 4pin plug adapter while the product page clearly said that there should be two. Now I ended up with two splitter but not enough adapter therefore still cannot make my LED strip…
Worked great for me. I wanted to run two 3M lengths in opposite directions from a central power source, and this let me do it easily. Liked that it came with two sets of pins, as one of my LED runs didn’t have one. For my application the cables could be a bit shorter, but I’d rather have them too long than too short. Haven’t noticed any flickering or dimming along my runs, but they’re also under 10M total length so the power supply can handle it fine. Maybe as an improvement, they could include…
Comments are disabled for this post.