This is a double-end input T8 1.5FT LED tube light with 7W total input power to replace 12-30V F15T8 energy-saving fluorescent. It is not dimmable and works from 10-30V DC.
****WARNIN I: It’s a 12-30V DC LED tube light! NEVER use it with AC 110/120VAC source unless you have an AC-DC converter to achieve 12-30V DC power. Please check your fixture voltage before buying****
****WARNING II: Actual Length 17-3/4″ pin to pin! Please measure your old bulb to confirm the fitness. ****
****Installation: Fixture Rewiring is Easy but Required! The installation manual is the 2nd photo at the upper left corner of this product page. The manual will also be enclosed inside the package shipped to you. Please ensure to follow the manual to install this LED light! It must be directly wired to your 12-30V DC power from the two input ends on both sides without the use of any electronic ballast or starter. Ask help from an electrician if you don’t have enough electrical basics! ****
Product Features
- Ideal for RV and Marine Lighting: To replace 12-30V DC 18″ CFLs with Instant-On Daylight 6000K!
- Actual length 17-3/4″ from pin to pin: Replace bulb with actual length from 17-5/8″ to 17-3/4″.
- Rotatable: light forwarding angle can be adjusted by +-90 degrees to fit any light fixture!
- Low heat, eco-friendly, and saving >50% electricity
- Fixture Rewiring is Easy but REQUIRED: Electronic ballast must be disconnected! **Installation Manual attached as the 2nd photo at the left upper corner of this product page!**
Perfect bulbs to resurrect old 1950’s era articulated table lamp Used these bulbs to repair a very old, 1950’s vintage, articulated table light. It no longer worked. It needed new ballasts for the flourescent bulbs. I could not find any that would fit. Saw these bulbs and cheered! It does require rewiring the lamp, removing the old ballasts that did not work anyway, the capacitors, etc. Also rewired the On / Off switch since no longer required the press and hold til light illuminates and then release function (this was a very old lamp). The wiring mod…
no guessing if fluorescent bulb or ballast is bad, very bright and much cooler temperature and cheaper …
Very Bright and Efficient
Comments are disabled for this post.