Introduction:
(2pcs/set)H11 Bridgelux COB LED headlight conversion kit
Super bright Bridgelux COB chip(USA),360 degree clear beam no blind zone
Engineering beam pattern design throw light on road evenly at appropriate angle without foggy light
Xenon white light reflect road paint/signs better to show clearer road situation
All-in-one heat conduction+high speed mute fan system keep the light bulb in appropriate working temperature
Built-in constant current CPU,instant full brightness without start-up relay
Technical Specification:
Plug Type: H11,single beam
Power: 72W/set(36W/bulb)
LED Quantity(each bulb): 2pcs* Bridgelux COB chips
Luminous Flux: 8000lm/set(4000lm/bulb)
Operating Voltage: DC 9-32V(fit 12V,24V vehicles)
Color Temperature: Pure White 6500K
IP65 rated water and dust seal,360 degree beam angle
Material: Aviation 6063 aluminum profile
Operating Temperature: -40-80 degree Celsius
Over 30000hrs lifetime
Usage: headlight,fog light
Two-way heat dissipation channel:
1.All-in-one aluminum profile as heat conduction system,360 degree heat radiating
2.High speed mute fan(12000R/Min),high Air flow for faster cooling rate
Package Included:
2x H11 LED headlight bulb
1x English installation manual
Product Features
- 2 Pcs of H11 single beam headlight bulbs, each with 3 pcs of high power Bridgelux COB chips. Apply for headlight and fog light.
- Super bright Bridgelux COB chip (USA), 360 degree clear beam no blind zone. Power: 72W/ set (36W/bulb), Luminous Flux: 8000lm (4000lm each bulb), Color Temperature: 6500K.
- Operating Voltage: DC 9-32V (fit 12V, 24V vehicles). Operating Temperature: -40-80 degree Celsius. Above 30,000 hours life time
- Xenon white light reflect road paint/signs better to show clearer road situation. Built-in constant current CPU, instant full brightness without start-up relay.
- All-in-one heat conduction + high speed mute fan system keep the light bulb in appropriate working temperature.
Bright! Arrived today, so I’ll update as things happen.cons,Installation took a little longer than expected (about an hour)1) I had to remove my battery to access one headlight (not an issue with the product, obviously).2) installation – EDIT: Apparently I didn’t read the instructions, you are supposed to remove the socket, install it, then push the light through. this would have made installation way easier.3) Make sure it’s plugged in correctly! The Plug will fit…
The plastic part on the bulb got lose and during …
Comments are disabled for this post.