){kind=link}
Product Feature:
Ultra long lasting design
Suit for back lighting and others
High Quality & Brightness COB LED chips
Low power consumption, save whole lot of energy
Product Description:
Input Voltage: DC 12V
Power: 10W
Luminous flux: 1000LM
Meterial: Aluminum Alloy plate+COB Led
Light Color: Warm White (3000-3500K)/ Pure White (6000-6500K)
Size: 12cm x 3.6cm – 4.72inch x 1.41inch / 20cm x 1cm – 7.87inch x 0.39inch
Package Included:
2 x 10W COB LED lamp
Note:
Requires a 12V LED driver to function correctly.
Product Features
- Ultra long lasting design
- Suit for back lighting and others
- 1000LM LED DC12V 10W,Light color: Warm/White
- Low power consumption, save whole lot of energy
- Brand New And High Quality & Brightness COB LED chips
Related Posts
New Ver. Led Strip Lights, Kwanan 32.8Ft(10M) Led Light Strip Kit Waterproof DC12V 5050RGB 300leds Flexible Strip Lights with Double PCB 44Key Remote,Stronger 3M Sponge Adhesive Tape and 5A Adapter √ Have you ever met the remote stop […] Posted in Rope and String Lights
50ft LED Round Rope Lights with Waterproof 540 LEDs Strip Lights Blue with 110V Two UL Certified Power Supply Cuttable Linkable String Lights with Connector and Accessory Pack
Durable and Safe for Use With two […] Posted in Rope and String Lights
Fluxtronics A19 LED Light Bulb, 75 Watt to 100 Watt Equivalent (11.2W), 1100 Lumens, Warm White (3000K), Non-Dimmable A19 LED Bulbs, E26 Base, UL Listed, 3 Years Warranty, 6-Pack
Product Features
★ ENERGY SAVINGS - […] Posted in LED Bulbs
CRAZY BRIGHT! i didnt recieve these for free or at a discount and my review is completely unbiased. these are crazy bright at 12volts. i wasn’t expecting the brightness and was staring right at it when i lit it up. i think it took a half hour or more before i started getting my vision back. i hooked up a digital multimeter and using a 12 volt auto battery (measured at 12.67 volts) at full brightness i measured 1.64 amps, or 20.78 watts. a previous reviewer said he measured 2.6 watts at 12 volts? not sure how…
Great for lighting up a car trunk
I installed these as under-hood lights in my Jeep and they work perfectly for that. They’re bright and run cool when each is in series with a 3.3 ohm current limiting resistor (needed since automotive 12V is up to 14+V when the engine is running). Soldering lead wires onto them was a breeze, although I had to set my iron to a much higher heat than normal due to the aluminum backing plate acting as a heatsink. A little liquid electrical tape over the solder points and wires to protect from…
Comments are disabled for this post.