){kind=link}
Light emitting diodes (LEDs) are low-voltage light sources that require a constant DC voltage or current to operate optimally. Because they operate on a low-voltage DC power supply, they easily adapt to different power supplies, have longer standby power, and are safer. LEDs require a device that can convert incoming AC power to the proper DC voltage and regulate the current that flows through the LED during operation. This Switching Power Supply LED driver converts 120V 60 Hz AC power to the 12 Volt DC power required by the LEDs and protects them from line-voltage fluctuations.
Ensure your LED lights do not exceed the maximum power output of the power supply.
Specifications
* Input Voltage: 100-240 VAC, 50/60 Hz
* Output Voltage: 12 VDC
* Output Wattage (max.): 48 W
* Current, Full Load: 4 A
* DC Plug Outer Diameter: 5.5 mm
* DC Plug Inner Diameter: 2.1 mm
* DC Plug Polarity: Center positive
* Cord Length: 60″ DC side, 48″ AC side
* Dimensions: 5″L x 2″W x 1.25″H
* IP Rating: IP30
* Compliance: UL, CE
* Warranty: 1 year
Product Features
- Energy efficient and stable 12V DC power supply
- 48W of maximum output power via a 5.5×2.1mm DC jack, center positive polarity
- CE and UL-listed with automatic thermal & overload cut-off, short circuit protection
- Detachable 48″ power cord with 3-prong plug
- Suitable for use with electronic devices that require 12V DC and require less than 48W of power
Related Posts
TORCHSTAR 4 Pack 22-inch LED Dimmable Under Cabinet Light, ETL & Energy Star Listed, 3 Color Levels, 3000K Warm white, 4000K Cool white, 5000K Daylight, Mounting Accessories Included, 3 Years Warranty
High-quality aluminum shell, more […] Posted in LED Lighting
GRV T10 921 194 24-3528 SMD LED Bulb lamp Super Bright Cool White DC 12V Pack of 10 Using For cabinet Lighting, RV, boat […] Posted in LED DC Bulbs
KATANA 9006 HB4 LED Headlight Bulbs,CREE Chips 12000Lm 6500K Extremely Bright Conversion Kit,360 Degree Adjustable Beam Angle Specification: 1. Model: 9006 HB4 2. […] Posted in LED Headlights
Really does seem to be EMI Free – That you! My big worry in any small switching power supply is EMI/RFI, as I’m a ham radio operator. When my kitchen was rebuilt a couple of years back, the contractor used a supply that looked JUST like this supply (slightly smaller by about 1/8″ in each direction) that generated noise spurs up and down the radio spectrum, and really took out the SW bandsThis supply is totally different. I replaced that “other” supply, and I can’t hear this supply, even with a SW receiver right…
Perfect Replacement Power Supply
Good supply for LED lighting Powering LED strip lighting with this. I bought a 15 ft reel of double-density 3528 type LEDs (600 LEDs/reel) and cut them to fit my kitchen cabinets, the whole strip draws 2.5 amps or 30W. I am running the adapter output thru a 12V pwm dimmer (aluminum case w/ 8A capacity), and at full brightness (30W) the adapter does get warm but it’s not too bad, I would not want to push the adapter over 80% of its rating though. Turn-on delay is noticeable but not too long, and the hum form the adapter…
Comments are disabled for this post.