LED Lighting Distributors

This is a Perfit PERFECT GLOW 16′; LED IP68 Full Waterproof RV Awning light kit w/ PC Mounting Channel for Permanent Installation. Like all of the products we sell they are used by the OEM’s and installed on brand new units everyday so they are tried and true… This kit is specifically designed for recreational vehicles, do not be fooled by the other sellers that sell the IP65 Crystal Resin “Waterproof” LED strip light with 3M. We have been down this path, it will not hold up to the elements. The OEM’s are using this Full Waterproof IP68 w/ Mounting channel in production units. This strip is covered in Crystal Resin like the IP65 but it’s also encased in another Silicone sleeve, this gives you double the protection from the elements. Then this LED strip is installed in the UV treated Polycarbonate mounting track/channel (The strip is held in place by it’s adhesive backing and compression by the channel) which is made right here in Elkhart, IN. w/ real commercial grade 3M adhesive tape.

Product Features

• Brand new, 16′ white with white awning light and channel
• BRIGHT LEDs
• Easily mounted
• 12 volt light
• How to install This strip can be mounted in many places, best place for mounting the LED Awning light is just under the Awning extrusion that is fastened to sidewall of your unit (Please see pics). This will allow the LED awning light to be hidden and protected with the awning is closed and revealed when the awning is in the open position. This is the most permanent, safest and easiest place to mount the awning light. When locating the light on the sidewall side of the unit it produces much better light and will not shine in your eyes while sitting on your porch. Select the location where you want to mount the light, take in account how you want to get the 12 volt power to this strip. We suggest starting the wire end of the strip near your porch or scare light so you can pull your 12V. power from this source. Clean the mounting surface with 3M adhesive promoter if possible, if not just use rubbing alcohol. Remove the 3M backer and install all 3 strips end to end along the awning extrusion. Please be careful and plan ahead, this channel will not come off once it has been applied. Remove the 3M backer from the LED strip, then insert (press to fit) the LED strip light into the PC channel. Start on the wire lead end and trim the PC channel on the opposite end if needed. Connect the Strip light wire lead to any 12V. switched source and enjoy your new Perfect Glow LED Awning light for 50,000 plus hours. Note: This is very easy for any DIY to do, we have seen customers run dedicated wire leads to the strip, tap into the Porch or Scare Light, or even put connectors on the leads and use a 110V. power converter. We will be offering a few different install kits and a 110V. connector/converter kit in the near future.