){kind=link}
Working Voltage: DC5V-24V
Current: 5A
Sensor Method: PIR
Delay Time: 15s
Cord Length: 0.3M
Detecting Range: 0-7M
Casing: black cover and white lens
Size: 48*25*14mm
Net Weight: 29g
Product Features
- Automatic Induction. The light will be activated at night or low-light environments by auto PIR motion detection
- The light will last for about 16 seconds after the infrared detection ceases
- 0 to 7 meters detecting range and high sensitivity
- Easy to install. Widely used on motion-activated lighting, LED strips
- Energy-saving and low heat and low power consumption
Related Posts
NEW SUN LED Trailer Fender Lights Pre-wired Dual Face LED Trailer Clearance Marker Lights Amber & Red – RH&LH This dual-faced trailer fender light […] Posted in Automotive![GearLight LED Pocket Pen Light Flashlight S100 [2 PACK] – Small, Mini, Stylus PenLight with Clip – Perfect Flashlights for Inspection, Work, Repair](https://ledlightingdistribution.com/wp-content/uploads/2018/05/51-xfvNbOEL-150x150.jpg)
GearLight LED Pocket Pen Light Flashlight S100 [2 PACK] – Small, Mini, Stylus PenLight with Clip – Perfect Flashlights for Inspection, Work, Repair GearLight S100 LED Pocket Flashlight […] Posted in LED Flashlights
XKTTSUEERCRR 54LED & 18LED 3 Flahing Modes Vehicle Windshield Dash Deck Grille Strobe Flash Emergency Hazard Warning Strobe Light Bar (Amber & White)
Bright strobe warning light for […] Posted in LED Lighting
I bought this to use with a 5m strand of RGB LED lights. It is so easy to hook up. You simply place it inline with the existing power to the LED lights. Then point the sensor towards the area you want to monitor. I found it catches my movement about 18-20 feet away and stays on for 15-16 seconds. This would be a 5 star if there was a little switch on it to change the time from 15 seconds, 30 seconds, 1 minute, etc. A couple of choices would be amazing.Now when I walk in the kitchen…
The Supernight motion activated switch for my strip lights works great. There are no directikvs, however it’s only 2 plugs and if is self explanatory. The plugs will only go in one way. Just plug the power adapter tip to the power adapter tip of the strip lights. There is also another plug that you hook up to the IR receiver for the remote. Once it’s all plugged in as long as there is movement it will stay light, when there is no movement lights will…
Comments are disabled for this post.