SiriusLED S3 9005 LED Headlight Bulb New Full Aluminum Structure 8000 Lumen Extremely Bright White 6000K Conversion Kit 2018 New
LEDdistributors • 7 years ago
Product Features
- 2018 All New Design S3 Model LED Headlight Conversion Kit with 8000 Lumen total output
- Patent pending LED Chip and driver combine in 1 metal body design technology to the best heat dissipation
- Fit: 9005, Extremely Bright with Customize LED Chip Maximum output 4000 Lumen each bulb
- Newer European and American car might require decoder to avoid flickering and bulb out error message
- we offer 1 year warranty for all our led that is confirmed with manufacture defective.

Related Posts
LE Dimmable 100W Bulbs Equivalent, 15W A21 E26 LED Bulbs, 1500lm, 200° Beam Angle,2700K Warm White, LED Light Bulbs ,pack of 4 units Pack of 4 Units
Energy Efficient. […] Posted in LED Bulbs
LED Light Bar, Northpole Light 42″ 240W Waterproof Spot Flood Combo LED Light Bar Jeep Off-road Lights LED Fog Lights with Mounting Bracket for Off-road, Truck, Car, ATV, SUV, Jeep Specifications: Beam: Spot-Flood Combo […] Posted in LED Bar Lights
Hykolity 16 Inch LED Ceiling Light, 25W [200W Equivalent] 4000K 1600lm BN Finish Dimmable Saturn Flush Mount Ceiling Light, ETL Listed for Hallway, Bathroom,Kitchen, Bedroom, Restroom, Walk in Closet Hykolity 16 Inch Brushed Nickel LED […] Posted in LED Lighting
Super Easy to Install – Brightness Exceeded My Expectations
I wanted to get rid of the “yellowish light” from the existing HID’s on my 2018 Subaru Legacy. I did a LOT of research on this and even send a message to the AUTO DOCTOR, a national column. I bought these over the myriad of other choices because the Auto Doctor recommended that I get the ones with the NEWEST DATE (introductory date.) This set had that.I did have one problem with one of the bulbs; the H11. Seems that the connector plug would not allow the bulb to connect to the car’s…
There is a flange that is held in place by a very small set screw which requires an allen key to remove (which is provided in the package). The set screw is used to remove the flange so that the retainer that holds the headlight bulb in the fixture can be put in place since the back end is too large fit through due to the fan and heatsink. The design flaw is that the screw should be a slotted design because the allen key head is far to easy to strip at this size. I attempted to use the supplied…
Comments are disabled for this post.